![]() 1 x centrifugal tank of stainless steel (1.4301).All seams are welded using plasma technology. This makes contacts of the honeycombs with the edge unproblematic. This gives a very high strength to the edge and guarantees next to the corrosion resistance also the food grade of the edge. The edge of the tank is crimped technically very complex. The stainless steel plate of the tank is expensive (about 5mm deep) deep-drawed into the discharge pipe of the cock and then soldered from the outside, thereby the draining honey has no contact to the solder joint! The honey runs on its own without tiresome tilting of the extractor. The bottom is sloping towards the pinch-cock. The pinch-cock is located at the lowest point of the bottom. The height of the outlet cock to the floor is 13 1/2" (34,5 cm). It is completely made of food-grade stainless steel (1.4301), with an easy replaceable food-grade rubber gasket. ![]() The outlet cock can be closed easily and securely. Only two screws have to be removed for cleaning and removal of the basket. Transverse and hand drive are screwed tight, the Plexiglas cover is rivetted. The Transverse is completely made of robust steel. In addition, the feets can be bolted to the floor, this grants a specific support and the honey extractor can not slip. The grid used for the stainless steel wire basket is from our supplier Hagen Feinstahl®.Ī 3-fold tank bottom edge roller-seam welded with an massive external stainless steel band and three sturdy legs of stainless steel (1.4301) provide the necessary stability. The ejection process can be observed through the plexiglass cover very well. The honecomb basket is exceptionally robust and easy to remove for cleaning. The mesh of the honeycomb basket is slightly rounded to the inner side in order to avoid a break of honeycombs. The drive has a bronze mounting of the axis of rotation, this grants a very long life.Ī gripper mechanic secures the opend lid, so it is guaranteed that the cover can not fall accidentally during loading and unloading. The crank and the housing are made of aluminum, the drive shaft and the gears are made of steel. If you push the handle in the opposite direction, the spin of the basket will be decelerated. ![]() The crank does not rotate on its own, only when they are served (no risk of injury). Robust hand drive 1:3 with freewheel and backpedalling brake. Height of the discharge valve 13 1/2" (34,5 cm) Lattice area of the honeycomb basket 10 1/4" x 17 6/8" (26 cm x 45 cm) honeycombs up to 10 5/8" x 19 5/8" (27 cm x 50 cm) can be centrifuged
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |